Information
Search

Articles

DIUS4 description

DIUS4 description

DIUS4 can be downloaded here: Before asking questions, please download and register an account in DIUS4 to see the available list of firmware. This will simplify the understanding of what is discussed in the description below. DIUS4 software does not work from the archive, you need to unzip the archive on the computer that will be used for DIUS4. Registration instructions are in the archive. Before starting registration, it is strongly recommended that you read the instructions. DIUS4 is a replacement for the previous version of DIUS Flasher 3. DIUS Flasher 3 is no longer in service.

Add Erase DESS Keys

Add Erase DESS Keys

Description The Keys page provides functions that you can use to add or erase DESS® keys. Keys The Key Usage table shows the status and, when available, the maximum RPM setting (on some 2-stroke) or type for each key.

Manual DIUS 4.0 for Reflash ECM for BRP

Manual DIUS 4.0 for Reflash ECM for BRP

The ECM Hardware number (HW) is an important parameter of ECM BOSCH Motronic ME17.8.5. Each firmware (SW) is designed for ECM with a specific Hardware number. DIUS 3 software allowed ECM programming only with firmware that was designed for the same HW number as the programmable ECM. Neglect of this restriction led to the failure of the ECM. DIUS 4 software supports firmware programming for ECMs with a different HW (changing the HW during process). Currently, in BRP vehicles are used ECMs

BUDS E 3.8.2.1 ALL PRODUCTS Edition

BUDS E 3.8.2.1 ALL PRODUCTS Edition

BRP Utility and Diagnostic Software (B.U.D.S.) Version: E3.8.2.1 (ALL_PRODUCTS Edition) Date: 2016.09.23 Designed by Kongsberg Inc. Copyright (C) 2000-2016, BRP inc. All rights reserved. What's New?

DIUS ULA- Universal lambda adapter

DIUS ULA- Universal lambda adapter

ULA - Universal Lambda Adapter (hereinafter - the device) is designed to control the quality of combustion of the fuel mixture using a BOSCH LSU 4.9 lambda sensor. Currently the device supports two modes of operation: 1. Lambda to CAN - designed to transfer the values ​​and operating parameters of the lambda over the CAN bus 2. Lambda to WiFi BRP - transmission of lambda readings and engine operation, temperature, etc. via WiFi to any device (phone, tablet, computer) with saving the log of the transport in the device for further downloading and processing data.

Now you can buy a license keys for BUDS

Now you can buy a license keys for BUDS

B.U.D.S. ( BRP Utility and Diagnostic Software) is a comprehensive multi-language diagnostic software that gives you an insight on BRP electronic modules. Using B.U.D.S. program, you can: Edit vehicle information Test, add or remove DESS keys Adjust engine parameters Activate module outputs Stop the engine Monitor vehicle parameters Troubleshoot vehicle faults Replace a module Update module software and/or calibration data Read and reset historical data Save vehicle information to disk Print vehicle information

Showing 1 to 6 of 6 (1 Pages)